Manual: systemd-storagetm

SYSTEMD-STORAGETM.SERVICE(8)			  systemd-storagetm.service			SYSTEMD-STORAGETM.SERVICE(8)

NAME
       systemd-storagetm.service, systemd-storagetm - Exposes all local block devices as NVMe-TCP mass storage devices

SYNOPSIS
       systemd-storagetm.service

       /usr/lib/systemd/systemd-storagetm [OPTIONS...] [DEVICE]

DESCRIPTION
       systemd-storagetm.service is a service that exposes all local block devices as NVMe-TCP mass storage devices. Its
       primary use-case is to be invoked by the storage-target-mode.target unit that can be booted into.

	   Warning

	   The NVMe disks are currently exposed without authentication or encryption, in read/write mode. This means network
	   peers may read from and write to the device without any restrictions. This functionality should hence only be
	   used in a local setup.

       Note that to function properly networking must be configured too. The recommended mechanism to boot into a storage
       target mode is by adding "rd.systemd.unit=storage-target-mode.target ip=link-local" on the kernel command line. Note
       that "ip=link-local" only configures link-local IP, i.e. IPv4LL and IPv6LL, which means non-routable addresses. This
       is done for security reasons, so that only systems on the local link can access the devices. Use "ip=dhcp" to assign
       routable addresses too. For further details see systemd-network-generator.service(8).

       Unless the --all switch is used expects one or more block devices or regular files to expose via NVMe-TCP as
       argument.

OPTIONS
       The following options are understood:

       --nqn=
	   Takes a string. If specified configures the NVMe Qualified Name to use for the exposed NVMe-TCP mass storage
	   devices. The NQN should follow the syntax described in NVM Express Base Specification 2.0c[1], section 4.5 "NVMe
	   Qualified Names". Note that the NQN specified here will be suffixed with a dot and the block device name before
	   it is exposed on the NVMe target. If not specified, defaults to "nqn.2023-10.io.systemd:storagetm.ID", where ID
	   is replaced by a 128bit ID derived from machine-id(5).

	   Added in version 255.

       --all, -a
	   If specified exposes all local block devices via NVMe-TCP, current and future (i.e. it watches block devices come
	   and go and updates the NVMe-TCP list as needed). Note that by default any block devices that originate on the
	   same block device as the block device backing the current root file system are excluded. If the switch is
	   specified twice this safety mechanism is disabled.

	   Added in version 255.

       --list-devices
	   Show a list of candidate block devices this command may operate on. Specifically, this enumerates block devices
	   currently present, and shows their device node paths along with any of their symlinks.

	   Added in version 257.

       -h, --help
	   Print a short help text and exit.

       --version
	   Print a short version string and exit.

SEE ALSO
       systemd(1), systemd.special(7)

NOTES
	1. NVM Express Base Specification 2.0c
	   https://nvmexpress.org/wp-content/uploads/NVM-Express-Base-Specification-2.0c-2022.10.04-Ratified.pdf

systemd 259.5											SYSTEMD-STORAGETM.SERVICE(8)